Olimpia splendid Unico Twin - Remote Control Reset and Wall Unit Power; Resetting Wall Unit Remote Settings; Turning the Wall Unit On and Off

UNICO TWIN
H
D9D1
D14
D19
D18 D16
D2 D4
D6 D8
D7D5D3
D17 D15
D10
D11
D12
D13
ENGLISH
EN - 37
DISPLAY
D1 Heating mode
D2 Cooling mode
D3 Dehumidicationmode
D4 Transmission of the command in progress
D5 Automatic mode
D6 Program 1
D7 Program switching off time setting
D8 Clock/program setting
D9 Program 2
D10 Program switching on time setting
D11 Temperature/time unit of measurement
D12 Lowbatterynotication
D13 Minutes timer
D14 Desired temperature/clock/programming
D15 Automatic ventilation speed
D16 Maximum ventilation speed
D17 Medium ventilation speed
D18 Minimum ventilation speed
D19 Function SILENT enabled
6.3.5 - RESETTING ALL REMOTE CONTROL FUNCTIONS
Replacing the batteries or removing them even for a few instants will cause all the settings of the remote
control to be reset.
In so doing, all the time settings of the timer saved in the remote control are cancelled and the remote control
restores all the factory settings.
6.4 - DESCRIPTION OF THE AIR CONDITIONER FUNCTIONS
• Thesystemcanbecontrolledusingtheremotecontrol.
To send the commands to the air conditioner, it is necessary to point the front part of the remote control
towards the appliance console.
The device emits a beep when it receives a command.
• Themaximumdistancefromwhichtheappliancecanbecontrolledisabout8meters(withchargedbat-
teries).
6.4.1 - TURNING THE UNIT ON/OFF
• PresskeyB1 on the remote control to activate or deactivate (stand-by) the air conditioner.
The control system of the unit is equipped with memory, for this reason all the settings won’t be lost when
shutting off the appliance itself.
In case of prolonged stop of the machine, it must be deactivated turning the main
switch off or unplugging the machine from the mains.