Note:
Make sure the front of the mechanism and the knob is facing the
front of the seat. There is a marking of FRONT on the mechanism
and the seat.
5
Align the Mechanism (4) over
the pre-drilled holes underneath
the Seat Cushion (2).
Then fix it with the Bolts (8) and
Wrench (12).
Step 3:
Position the assembled chair upright
with the Seat Mechanism (4) facing
down. lnsert the Gas Lift (5) into the
center hole of the Seat Mechanism (4)
and press down until fully engaged.
Step 4:
(8)×4
(2)
(4)
3
4
To Next Page
Loading...