36
CASY TT Operator‘s Guide
MAIN MENU – System Settings
. MAIN MENU – System Settings
System Settings contains settings relevant to the entire system. The Graph Parameter function
allows you to specify up to four measuring parameters that you wish to be displayed in the upper
section of the size distribution screen. The Used Setups for Capillary function allows you to delete
setups not needed anymore.
SYSTEM SETTINGS TT-2AB-9999 15.04.2009 10:15
1. Graph Parameter: Conc. Range CON
2. Graph Parameter: Aggregation AGG
3. Graph Parameter: Viab.Cells/ml LML
4. Graph Parameter: %Viability VIA
Used Setups for Capillary 150 µm:
Setup No: 00 01 02 03 04 05 06 07 08 09
* * * *
10 11 12 13 14 15 16 17 18 19
* *
USE MENU AND NEXT TO STEP. USE +/- TO EDIT.
USE CANCEL TO LEAVE SCREEN OR ENTER TO CONFIRM CHANGES.
All measuring results, date and time and the used setup can be selected as Graph Para meters.
Each parameter has its own abbreviation consisting of up to three characters, which is used to dis-
play the relevant value in the size distribution screen. The following values are available:
Description Abbreviation Description Abbreviation Description Abbreviation
not used --- Viab.Cells/ml LML Peak Diameter PDI
Conc. Range CON %Viability VIA Mean Volume MVL
Counts CNT Debris/ml DML Peak Volume PVL
Counts > C> Volume/ml VML Date DAT
Aggregation AGG %Volume %V Time TIM
Counts/ml CML Total/ml TML Setup SET
%Counts %C Mean Diameter MDI
You can step to the settings of the 4 parameters by pressing MENU. The required parameters are
selected from the predened values as indicated in the table using the and keys.
If not used is selected, the corresponding position in the upper section of the size distribution
screen remains empty.
To Next Page
Loading...