Read the assembly manual thoroughly and observe the information contained during installation.
Keep the assembly manual in a safe place for future reference.
Intended Use
The additional door lock increases property security when residents are inside the respective building
or room. Option: The installation of an outer cylinder enables the additional lock to be used on the door
even when the user is absent.
The additional door lock is intended for apartment and house entrance doors made of wood, steel, alu-
minium and composite materials. In the case of plastic and compound materials, a metallic prole must
be available at the assembly positions or a metallic plate underlaid on the other side.
Any other use is considered unintended use. Unauthorised modications or reconstructions not de-
scribed in the manual are not permitted and could cause the product to be damaged.
Safety Instructions
WARNING! Risk of suocation! Children can swallow small parts,
packaging and protective foils. Keep the product and packaging
out of reach of children!
IMPORTANT! Improper assembly can lead to property damage. Install the
additional door lock as described in this assembly manual. Only use the
assembly material supplied.
IMPORTANT! DO NOT use spray oils or anything similar. Clean the catch oc-
casionally with a dry cloth. The mechanism inside is already greased at the
factory. During assembly, pay attention that no wood chippings or similar
bits get into the lock cases when open.
Lock Unit
1 Lock case
2 Base plate
3 Screw M5x10
4 Screw 5x25
Door Lock RS 50
5 Spacer base plate
6 Screw 5x35
7 Frame dowel
8 Additional spacer plate
9 Strike plate
10 Screw M5x15
11 Lock case
12 Screw M5x15
Assembly Manual
Door Lock RS 50R
13 Door guard
14 Retaining bolt
15 Retaining bolt spring
16 Safety cotter pin
Tools Required
■ Cross-tip screwdriver
■ 3 mm wood drill
■ 10 mm masonry drill
■ Marker, scriber
■ Possibly a tape measure and
spirit level
C1
2
4
C2
1
3
11
12
10
9
8
6
5
7
13
14
15
16
Lock Unit
Door Lock RS 50R
Door Lock RS 50
Additional Door Lock RS 50 / Additional Door Lock RS 50R
Option (when using an
outer cylinder)
■ 32 - 35 mm hole cutter
■ Pliers to shorten the catch
To Next Page
Need help?
General