Point the camera towards a
subject while viewing through the
viewfinder or the monitor.
2
Press the shutter button halfway.
● The green lamp lights up.
Press the shutter button all the way to
start recording.
● The card access lamp blinks and the camera
starts writing the movie to the card.
● During movie recording, lights in red.
Press the shutter button all the way again to stop recording.
● If the displayed seconds remaining reach “0”, shooting finishes
automatically and the camera starts writing the movie to the card.
Remove the lens cap. Set the mode dial to and press
the POWER switch.
1
3
4
5
Card access lamp
Seconds remaining
Green lamp
To Next Page
Loading...
