17
Connecting the USB Reader (using without other peripheral devices)
Connect to the Reader by using the attached USB cable, connect the card
reader to the USB port located at the back of the computer. Make sure the
cable ends are firmly connected.
The USB cable may be plugged into the computer while the computer is running, however,
the device drivers must be installed first.
Connecting the USB SmartMedia Reader
to a Computer
PC tower connec-
tion
G3 tower connection
iMac computers with
OS 8.1+ and USB suppliment 1.1
!
Be careful not to confuse the upper and lower parts of the connector. Do not force
connections, as this may damage the connection or the card reader.
To Next Page
Loading...