Olympus EPOCH 650 - DMTA-10055-01 EN, Rev. A, February; Table 5 Filter Cutoffs

DMTA-10055-01EN, Rev. A, February 2015
Software Overview 57
The following receiver parameters are available for live adjustments in the Rcvr
menu:
• Filter: Receiver filter setting
• Rect: Waveform rectification (Full full wave, Half+ half wave positive, Half– half
wave negative, RF no rectification)
• Reject: Percent reject (from 0 % to 80 %)
The 30 filters available on the EPOCH 650 allow broadband or narrowband settings to
match the requirements of a given application. Each filter is a fully digital filter set.
Table 5 on page 57 lists the low-pass and high-pass cutoffs for each available filter.
Table 5 Filter cutoffs
0.2 MHz−10 MHz 2.0 MHz−21.5 MHz
8.0 MHz−26.5 MHz 0.5 MHz−4.0 MHz
0.2 MHz−1.2 MHz 1.5 MHz−8.5 MHz
5.0 MHz−15 MHz DC− 10 MHz
DC−1.2 MHz DC−4.0 MHz
DC−8.5 MHz DC−15.0 MHz
DC−26.5 MHz 0.2 MHz−4.0 MHz
0.2 MHz−8.5 MHz 0.2 MHz−15.0 MHz
0.2 MHz−26.5 MHz 0.5 MHz−10.0 MHz
0.5 MHz−8.5 MHz 0.5 MHz−26.5 MHz
0.5 MHz−15.0 MHz 1.0 MHz−3.5 MHz
1.5 MHz−10.0 MHz 1.5 MHz−15.0 MHz
1.5 MHz−26.5 MHz 2.5 MHz−7.0 MHz
5.0 MHz−10.0 MHz 5.0 MHz−26.5 MHz
6.0 MHz−12.0 MHz 8.0 MHz−15.0 MHz