EasyManua.ls Logo

Olympus FE-320 - Page 56

Olympus FE-320
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
·Battery
Handling.
Precaufion.s·
o This camera uses a lithium ion battery specified by Olympus. Do not use any other type
of
battery.
For safe and proper use, read the battery's instruction manual carefully before using it.
o If the battery's terminals get wet or greasy, camera contact failure may result. Wipe the battery well
with a dry cloth before use.
o Always charge a battery when using it for the first time, or if it has not been used for a long period.
When operating the camera with battery power at low temperatures, try to keep the camera and
spare battery as warm as possible. A battery that has run down at low temperatures may be
restored after it is warmed at room temperature.
The number of pictures you can take may vary depending
on
the shooting conditions or battery.
o Before going on a long trip, and especially before traveling abroad, purchase extra batteries. A
recommended battery may be difficult to obtain while traveling.
Please recycle batteries to help save our planet's resources. When you throwaway dead batteries,
be sure to cover their terminals and always observe local laws and regulations.
Do
not push the monitor forcibly; otherwise the image may become vague, resulting
in
a playback
mode failure or damage to the monitor.
A strip
of
light may appear on the top/bottom of the monitor, but this is not a malfunction.
o When a subject is viewed diagonally
in
the camera, the edges may appear zigzagged
on
the
monitor. This is not a malfunction; it will be less noticeable
in
playback mode.
o
In
places subject to low temperatures, the LCD monitor may take a long time to turn
on
or its color
may change temporarily. When using the camera
in
extremely cold places, it is a good idea to
occasionally place it
in
a warm place. An LCD monitor exhibiting poor performance due to low
temperatures will recover
in
normal temperatures.
The LCD used for the monitor is made with high-precision technology. However, black spots or
bright spots of light may appear constantly on the LCD Monitor. Due to its characteristics or the
angle at which you are viewing the monitor, the spot may not
be
uniform
in
color and brightness.
This is not a malfunction.
Olympus makes no representations or warranties regarding any damages, or benefit expected by
using this unit lawfully, or any request from a third person, which are caused by the inappropriate
use
of
this product.
o Olympus makes no representations or warranties regarding any damages or any benefit expected
by using this unit lawfully which are caused by erasing picture data.
><
0 Olympus makes no representations or warranties, either expressed or implied, by or concerning
"'0
any content
of
these written materials or software, and
in
no event shall be liable for any implied
as
warranty
of
merchantability or fitness for any particular purpose or for any consequential, incidental
0..
or indirect damages (including but not limited to damages for loss of business profits, business
«
0..
interruption and loss
of
business information) arising from the use or inability to use these written
materials or software or equipment. Some countries do not allow the exclusion or limitation
of
liability for consequential or incidental damages, so the above limitations may not apply to you.
o Olympus reserves all rights to this manual.
Warning
Unauthorized photographing or use
of
copyrighted material may violate applicable copyright laws.
Olympus assumes no responsibility for unauthorized photographing, use or other acts that infringe
upon the rights of copyright owners.
56
EN

Other manuals for Olympus FE-320

Related product manuals