DMTA-10026-01EN, Rev. D, January 2015
Using Special Functions
101
If you forget the password, you can unlock the instrument and deactivate the
password by entering the master password “OLY8600”.
When you want to change the password, you must first use the master password to
deactivate the password, and then set a new password.
3. Select SET to set the password and return to the measurement screen.
To lock and unlock instrument functions
1. In the measurement screen, press [SET UP], and then select INSTRUMENT
LOCK.
2. In the INSTRUMENT LOCK SETUP screen (see Figure 5-11 on page 101), enter
the password in the PASSWORD field (if a password was set), and then lock or
unlock as follows:
a) Set CALIBRATION to ON or OFF in order to lock or unlock this function.
b) Set SETUP MENU to ON or OFF in order to lock or unlock this menu.
c) Set FILE MENU to ON or OFF in order to lock or unlock this menu.
d) Select SET to activate or deactivate the instrument locks and return to the
measurement screen.
OR
Select CANCEL to discard the changes.
Figure 5-11 The INSTRUMENT LOCK SETUP screen
To Next Page
Loading...
