DMTA-10026-01EN, Rev. D, January 2015
Configuring the Instrument
105
LOW (0.1 mm [0.01 in.])
HIGH (0.001 mm [0.0001 in.])
6. In DISPLAY UPDATE RATE, adjust the number of thickness updates of the
display per second to one of the following rates: 4 Hz, 8 Hz, 16 Hz, or 20 Hz.
The DISPLAY UPDATE RATE only controls the rate at which the thickness displays
are updated. The instrument internal measurement rate is 60 Hz. This ensures that the
minimum and maximum thickness readings are being captured at the 60 Hz
measurement rate (see “Adjusting the Display Update Rate” on page 57).
7. Set ID OVERWRITE PROT to ON if you want to see a confirmation message in
the help bar when attempting to save a measurement reading in an ID that
already contains a value (see “Setting the ID Overwrite Protection” on page 129
for details).
8. Press [MEAS] to return to the measurement screen.
6.2 Configuring System Parameters
The SYSTEM screen allows you to configure many Magna-Mike 8600 system
parameters.
To configure system parameters
1. In the measurement screen, press [SET UP], and then select SYSTEM to display
the SYSTEM SETUP screen (see Figure 6-2 on page 106).
2. Set BEEPER to ON or OFF (see “Setting the User Interface Language and Other
System Options” on page 51 for details).
3. Set INACTIVE TIME to ON or OFF (see “Setting the User Interface Language
and Other System Options” on page 51 for details).
4. In LANGUAGE, select the desired user interface language (see “Setting the User
Interface Language and Other System Options” on page 51 for details).
5. Set RADIX to the desired character to be used to separate the integer and the
decimal numbers: PERIOD (.) or COMMA(,).
6. Set the PROBE BUTTON to assign the button to a specific function: Q-CAL,
SAVE, SEND, or MEAS.
To Next Page
Loading...
