DMTA-10026-01EN, Rev. D, January 2015
Chapter 7
126
When scrolling through the file names, a descriptive header for the highlighted file
name appears on the lower section of the display. This information can assist in
selecting the proper file if you are uncertain of the exact file name.
a) To rename the file, edit the NAME value.
b) Edit the file description (DESCRIPTION), the inspector identification
(INSPECTOR ID), and the location note (LOCATION NOTE) values as
needed.
c) To change the file lock state, set DELETE PROTECTION to ON or OFF.
Figure 7-11 Entering new file information
3. Select UPDATE to return to the measurement screen.
7.3.4 Deleting a File or Its Contents
You can use the file delete function to completely erase the file from the datalogger
memory or to erase the contents of a file. Files that are delete-protected cannot be
deleted until the delete protection is disabled (see “Editing a File” on page 125).
To Next Page
Loading...
