DMTA-10026-01EN, Rev. D, January 2015
Chapter 7
130
Figure 7-15 on page 130 shows an example of ID review screen and describes its
contents. The flags are the same single letter abbreviations for status words that are
transmitted by the gage using the send commands.
Figure 7-15 The ID REVIEW screen
The ID review screen has three purposes:
• Review datalogger contents by scanning through stored ID locations in the active
file.
• Move within the data file and change the current ID location to any location that
already exists in the data file.
M: Standard measurement
L: (LOS) loss of measurement
L: LOW alarm
H: HIGH alarm
A: Alarm ON
--: Alarm OFF
--: Differential OFF
D: Normal differential
d: Percent differential
m: Minimum mode is ON.
M: Maximum mode is ON.
--: Both MIN and MAX modes are
OFF.
B: Both MIN and MAX modes are
ON.
n: MIN mode is ON but not MIN
measurement value found.
x: MAX is ON but not MAX
measurement value found.
N: Both MIN and MAX are ON
and measurement is minimum.
X: Both MIN and MAX are ON
and measurement is maximum.
Stored thickness
value
ID#
Probe type indicator
Ball/target size indicator
File name
Minimum (MIN),
maximum (MAX), and
differential (DIFF) values
(if active when saved)
To Next Page
Loading...
