DMTA-10026-01EN, Rev. D, January 2015
Chapter 8
142
8.4.1 Sending Entire Files (RS-232)
You can send a single or all files from the Magna-Mike 8600 to a computer or other
device. The data that is transmitted includes the file name, the file header, ID
numbers, thickness data, flags, and calibration setups.
To send entire files from the Magna-Mike 8600 to a computer
1. Ensure that the RS-232 communication parameters are configured correctly (see
“Setting Up RS-232 Serial Communication” on page 139).
2. In the measurement screen, press [FILE], and then select SEND.
3. In the FILE SEND screen (see Figure 8-4 on page 142):
Choose SELECTED to send a single file.
OR
Choose ALL to send all files.
4. If you chose SELECTED, highlight the desired file in the list, and then press
[ENTER] to select the file.
OR
If you chose ALL, just press [ENTER].
5. Select SEND at the bottom of the screen.
The following message may appear on the help text bar while the data is
transferred: “Processing. Please wait”.
Figure 8-4 The FILE SEND screen
To Next Page
Loading...
