Olympus Magna-Mike 8600 - Resetting the Communication Parameters; Figure 8-8 the COMMUNICATION RESET Screen; Table 18 Default Communication Parameter Values

DMTA-10026-01EN, Rev. D, January 2015
Chapter 8 148
8.7 Resetting the Communication Parameters
The communication reset function quickly returns communication parameters to the
factory default values. This function may be useful when you experience difficulties
to establish the communication with a remote device. Table 18 on page 148 gives the
default values for the communication parameters.
To reset the communication parameters
1. Press [SET UP], and then highlight RESET (see Figure 8-8 on page 148):
2. In the RESET submenu, select COMMUNICATION to display the
COMMUNICATION RESET screen (see Figure 8-9 on page 149).
3. Select RESET to reset the communication parameters.
OR
Select CANCEL or press [MEAS] to abort the operation.
Figure 8-8 The COMMUNICATION RESET screen
Table 18 Default communication parameter values
Parameter Va lu e
PROTOCOL MULTI CHAR
OUTPUT FORMAT F1
CONNECTION TYPE USB