DMTA-10026-01EN, Rev. D, January 2015
Software User Interface Elements
47
2.2 Menus and Submenus
The Magna-Mike 8600 displays menus and submenus when you press some of the
front panel keys. The menu appears at the top left-hand corner of the screen (see
Figure 2-3 on page 47). If applicable, a submenu also appears, conveniently showing
the parameters available for the highlighted menu command.
Figure 2-3 Menu and submenu example
To select a menu or a submenu command
1. Press [SET UP], [MIN/MAX], [DISPLAY], or [FILE] on the instrument keypad to
display a menu.
2. Press [] and [] to highlight the desired menu command.
3. If applicable and needed, press [] to move the highlight to the submenu, and
then press [] and [] to highlight the desired submenu command.
4. Press [ENTER] to select the highlighted menu, or submenu command.
In the remainder of this document, the above procedure is summarized by simply
stating to select a specific menu or submenu command. For example: “In the menu,
select MEASUREMENT.”
Menu
Submenu for the
highlighted menu
command
To Next Page
Loading...
