Olympus Magna-Mike 8600 - Selecting the Measurement Units; Figure 3-1 the SYSTEM SETUP Screen

DMTA-10026-01EN, Rev. D, January 2015
Chapter 3 52
3. In the SYSTEM SETUP screen (see Figure 3-1 on page 52):
a) Set the BEEPER to ON or OFF.
b) Set the INACTIVE TIME to ON or OFF.
c) Set the LANGUAGE to the desired language.
d) Set the RADIX to the desired character to be used to separate the integer and
the decimal digits: PERIOD (.) or COMMA (,).
e) Assign the PROBE BUTTON to a specific function: Q-CAL, SAVE, SEND, or
MEAS.
f) Assign the FOOT SWITCH to a specific function: Q-CAL, SAVE, SEND, or
MEAS.
Figure 3-1 The SYSTEM SETUP screen
4. Press [MEAS] to return to the measurement screen.
3.2 Selecting the Measurement Units
You can set the Magna-Mike 8600 to show thickness measurements in inches or
millimeters.
To set the measurement units
1. In the measurement screen, press [SET UP], and then highlight
MEASUREMENT.
2. In the MEASUREMENT submenu, select UNITS.