Olympus Magna-Mike 8600 - Setting the Clock; Figure 3-2 the MEASUREMENT SETUP Screen - UNITS

DMTA-10026-01EN, Rev. D, January 2015
Initial Setup 53
3. In the MEASUREMENT SETUP screen (see Figure 3-2 on page 53), set UNITS to
ENGLISH or METRIC.
4. Press [MEAS] to return to the measurement screen.
Figure 3-2 The MEASUREMENT SETUP screen — UNITS
3.3 Setting the Clock
The Magna-Mike 8600 has a built-in date and time clock. You can set the date and the
time, and select their respective format. The Magna-Mike 8600 saves all
measurements value with their acquisition date.
To set the clock
1. In the measurement screen, press [SET UP], and then highlight CLOCK.
2. In the CLOCK submenu, select the desired parameter: MONTH, DAY, YEAR,
DATE MODE, HOUR, MINUTE, or HOUR MODE.
3. In the CLOCK SETUP screen (see Figure 3-3 on page 54):
a) Set the date parameters to the current date: MONTH, DAY, and YEAR.
b) Set the DATE MODE to the desired format: MM/DD/YYYY or
DD/MM/YYYY.
c) Set the time parameters to the current time: HOUR and MINUTE.
d) Set the HOUR MODE to the desired format: 12 HOUR or 24 HOUR.