Olympus Magna-Mike 8600 - Table 6 Magna-Mike 8600 Targets

DMTA-10026-01EN, Rev. D, January 2015
Basic and Multipoint Calibration 71
Table 6 Magna-Mike 8600 targets
Olympus
part
number
Description Application
Maximum
thickness
(with
standard
wear tip)
Maximum
thickness
(with
chisel
wear tip)
Maximum
thickness
(with low-
profile
probe
86PR-3)
80TB1
(U8771030)
1.59 mm
(1/16 in.)
target ball
Thin or
compressible
material with
intricate geometry.
2.03 mm
(0.080 in.)
2.03 mm
(0.080 in.)
2.03 mm
(0.080 in.)
80TB2
(U8771031)
3.18 mm
(1/8 in.)
target ball
General
applications for
plastic bottles.
6.10 mm
(0.240 in.)
4.06 mm
(0.160 in.)
4.06 mm
(0.160 in.)
80TB3
(U8771032)
4.76 mm
(3/16 in.)
target ball
Thicker material
where a 4.76 mm
(3/16 in.) ball will
roll freely.
9.14 mm
(0.360 in.)
6.10 mm
(0.240 in.)
Not
available
80TB4
(U8771033)
6.35 mm
(1/4 in.)
target ball
Thicker
noncompressible
material where a
6.35 mm (1/4 in.)
ball will move
freely.
12.70 mm
(0.500 in.)
9.14 mm
(0.360 in.)
Not
available
86TBM3
(U8771039)
Magnetic
4.76 mm
(3/16 in.)
target ball
Thicker material
where a smaller
target ball is needed
due to contours.
19.05 mm
(0.750 in.)
19.05 mm
(0.750 in.)
Not
available
86TBM4
(U8771040)
Magnetic
6.35 mm
(1/4 in.)
target ball
Noncompressible
material where
maximum thickness
capability is needed.
25.40 mm
(1.00 in.)
25.40 mm
(1.00 in.)
Not
available
80TD1
(U8771034)
Flat disk
12.70 mm
(0.500 in.)
Thin channels
where a standard
target ball will not
roll freely.
9.14 mm
(0.360 in.)
9.14 mm
(0.360 in.)
Not
available