Olympus Magna-Mike 8600 - Calibration Accessory Kits

DMTA-10026-01EN, Rev. D, January 2015
Chapter 4 72
4.5.5 Calibration Accessory Kits
The Magna-Mike 8600 has six different calibration kits available, depending on the
type of target ball, disk, wire, and the maximum thickness of your application.
• Standard kit for most applications (Olympus P/N: 86ACC-KIT)
• Extended range calibration kit (Olympus P/N: 86ACC-ER-KIT)
• Target disk calibration kit (Olympus P/N: 86ACC-D-KIT)
• Wire target calibration kit (Olympus P/N: 86ACC-W-KIT)
• Low-profile probe calibration kit (Olympus P/N: 86ACC-PR3-KIT)
• Set of six NIST traceable standards (Olympus P/N: 80CAL-NIS)
80TD2
(U8771035)
Knife edge
(V) disk
6.35 mm
(1/4 in.)
Small channels
where the 80TD1
disk will not roll
freely.
6.10 mm
(0.240 in.)
6.10 mm
(0.240 in.)
Not
available
86TW1
(U8771041)
Wire target
1.14 mm
(0.045 in.)
Wall thicknesses in
holes or small
diameter openings.
12.70 mm
(0.500 in.)
12.70 mm
(0.500 in.)
Not
available
86TW2
(U8779858)
Wire target
0.66 mm
(0.026 in.)
Wall thicknesses in
holes or small
diameter openings.
6.10 mm
(0.240 in.)
6.10 mm
(0.240 in.)
0.160 in.
(4.06 mm)
Table 6 Magna-Mike 8600 targets (continued)
Olympus
part
number
Description Application
Maximum
thickness
(with
standard
wear tip)
Maximum
thickness
(with
chisel
wear tip)
Maximum
thickness
(with low-
profile
probe
86PR-3)