4.2 Command line installation
The command line installation is useful if you want to install RecMic Configuration Tool across a network to
multiple computers. This section describes information on how to use command line options.
4.2.1 Language options
When the installation of RecMic Configuration Tool is started from setup.exe, you can select the language
that you want to use during installation. This is also used as the default display language of RecMic
Configuration Tool.
You can specify the language when you use the command line installation.
Syntax
• To install using setup.exe, use the following syntax:
setup.exe /L<Language ID>
• To install using msiexec, use the following syntax:
msiexec /i RecMicConfiguration.msi TRANSFORMS=<path to MST>
The table below lists parameters for language options.
To Next Page
Loading...
