Olympus TG-1 - Page 52

52
EN
Displaying the current altitude/water
Displaying the current altitude/water
depth (atmospheric/hydraulic pressure)
depth (atmospheric/hydraulic pressure)
[Manometer]
[Manometer]
d
(Settings Menu 3)  Tough Settings
 Manometer
The readings may have a margin of error depending
on meteorological conditions. Use the readings only
for your reference.
Submenu 2 Submenu 3 Application
Manometer
Off
Cancels the manometer
display.
On
Displays the current
altitude/water depth
(atmospheric/hydraulic
pressure) in the shooting
standby mode screen.
(–12 m to 5,000 m)
Calibrate
Proceed to the setting
screen. See below.
When set to [On], a warning message appears in the
monitor as a water depth close to 10 m (32.8 ft) is
reached.
To adjust the altitude/water depth display
To adjust the altitude/water depth display
1 Use FG to select the current altitude/water depth,
and press the A button to set.
MENU
1200m1200m
Calibrate
Back
Setting the units of elevation, depth,
Setting the units of elevation, depth,
etc. [m/ft settings]
etc. [m/ft settings]
d
(Settings Menu 3)  Tough Settings
 m/ft settings
Submenu 2 Submenu 3 Application
m/ft settings
m This displays in meters.
ft This displays in feet.
Operating the camera by tapping the
Operating the camera by tapping the
body [Tap Control]
body [Tap Control]
d
(Settings Menu 3)  Tough Settings

Tap Control
Submenu 2 Submenu 3 Application
Tap Control
Off Cancels [Tap Control].
On [Tap Control] is activated.
Calibrate
Adjusts the tap strength
and intervals between
multiple taps on each side
of the camera body. (top,
left, right, & back)
Operating during shooting mode
Operating during shooting mode
(Example: Flash mode)
(Example: Flash mode)
1
Tap the right or left side of the camera body once.
●
The fl ash mode selection screen is displayed.
2
Tap the right or left side of the camera body to select a
function.