15. USPM Setup Procedure
PV6253-F4E016 64
15. USPM Setup Procedure
The method for setting up USPM-RU Ver. 3.21 again will be explained.
[Note 1] USPM-RU Ver. 3.21 is software capable of running on Windows XP. However, notice that
Olympus is not in a position to guarantee operation with any other software than the one
initially installed.
15.1. Setup of device driver
When a USB type control box is in use:
With the personal computer started, connect it to the control box through a USB cable, and turn on
the power of the control box.
The Windows XP Hardware Wizard will automatically start up.
Specify the location of the device driver. Load the Install CD-ROM in the CD-ROM drive, and
press the [Specify Location] button. Furthermore, specify "D:¥Driver¥CP2101¥Win¥" with the
[View] button, and close with [OK].
Close the Hardware Wizard with the [Complete] button.
When a GP-IB type control box is in use:
With the personal computer started, load the GP-IB PC Card in the slot. Then, the Windows XP
Hardware Wizard will automatically start up.
Specify the location of the PC Card driver. Load the Install CD-ROM in the CD-ROM drive, and
press the [Specify Location] button to display the [Specify Location] window. Furthermore,
specify "D:¥Driver¥REX5052¥Win¥" with the [View] button, and close with [OK].
Close the Hardware Wizard with the [Complete] button.
To Next Page
Loading...
