PV6088-F4E017
2.2. How to carry and install the product
Keep the following cautions in mind when installing the product:
(1) Remove the main unit, cables and accessories from the shipping box.
(2) Check whether all of the items listed in [Packaged Items] are in place.
(3) Remove the packing materials and check whether there is any visible damage to
the contents.
(4) Set up the main unit, the control box, the light source power supply and computer
into a place that satisfies the installation conditions.
Always firmly hold the base when carrying or installing the product.
Otherwise there is a risk of failure.
Always use two or more persons to unpack, install or carry the
device, which weighs about 20 kg. Handling the device alone may
cause injury.
Do not allow any impact to occur to the device when unpacking or
installing it. Damage to optical parts or undesired effects to the
sample adjustment feature of the product may result, causing failure
or incorrectness.
Avoid installing the product in an unstable place or any place with
strong vibrations. There is a risk of the unit overturning or falling, or
injury. Take the usage conditions into consideration when installing
it.
Do not place equipment so that it is difficult to pull out power supply
cord from rear side receptacle of Control Box and Light Source
Power Supply
To Next Page
Loading...
