Technical data - Truck identification
Technical data - Truck identification
Lift the truck as follows:Lift the truck as follows:
•• InserInsert a t a non-mnon-metalletallic cic cable able (1) th(1) through rough the rthe rear tear tow how hook ook (2) o(2) of the f the trucktruck. Ma. Make ske sureure
that the cable lies in the upper portion of that the cable lies in the upper portion of the hollow in the ballast.the hollow in the ballast.
•• InserInsert two t two cablcables (3es (3), on), one foe for eacr each sih side, de, througthrough the h the upper upper croscrossbar sbar (4) o(4) of the f the fixedfixed
upright of the mast.upright of the mast.
•• AttacAttach the h the ends ends of the of the cablcables to es to the cthe crane hrane hook aook and lnd lift tift the truhe truck wck withouithout jolt jolting ting it.it.
ATTENTION:ATTENTION:
The cables should be long enough that they do not touch the roof orThe cables should be long enough that they do not touch the roof or
other equipment while other equipment while the truck is being lthe truck is being lifted. ifted. Use a swinging bar iUse a swinging bar if necessary.f necessary.
Pull the cables Pull the cables vertically.vertically.
To Next Page
Loading...