Setting Up the Pump(s)
3
3-5
1. Refer to Figures 3-1 through 3-3. Perform Steps 1, 2 and 3 in
Section 3.3.1 to put the first pump on the face of the motor.
2. Refer to Figure 3-5 and Figure B. Make sure the second pump is
in the closed position.
3. Refer to Figure 3-6 and Figure B. Place the blade of the flathead
screwdriver in the groove of the Rotor Shaft (5) of the second
pump. Rotate the Rotor Shaft of the second pump until it’s back
tab slips into the groove of the Rotor Shaft of the first pump.
4. Refer to Figure 3-7. With the pumps and motor aligned, insert the
optional LONG mounting screws through the mounting holes in
both pumps, until they make contact with the threaded mounting
holes in the motor.
5. Tighten the long screws fully with a small flathead screwdriver.
For technical details on stacking more than 2 pumps, refer to
Chapter 8.
Parts of the Pump
Figure B
To Next Page
Loading...