ASSEMBLY
Note: For best results, go through the assembly procedures, carefully
noting all cautionary points and hints, which are included for your
understanding and benefit.
STEP 1 Place Bowl on Motor Base Housing with spout facing forward
and in the middle of the two raised projections.
STEP 2 Place Citrus Base onto Bowl.
STEP 3 Insert Citrus Strainer Cone onto Citrus Base.
STEP 4 Place the ends of the latch arms over the ridge of the Citrus
Base. Push down Latch Arm Handle to lock Latch Arm in place.
DISASSEMBLY
STEP 1 Pull the Latch Arm Handle out to unlock the Latch Arm.
Move the ends of the latch arms from over the ridge of the Citrus Base.
STEP 2 Remove the Citrus Strainer Cone from the Citrus Base.
STEP 3 Remove the Citrus Base from the Bowl.
STEP 4 Remove the Bowl from the Motor Base Housing.
USING THE MODEL 5000
After Assembly, plug the power cord into an electrical outlet.
Turn the power switch to the on position.
Place one-half orange, grapefruit, lemon, or lime on Citrus Strainer
Cone and push down firmly. The Citrus Strainer Cone will only rotate
when pressure is applied.
Should the Citrus Strainer Cone become filled with seeds and pulp before
you have completed juicing, turn off the juicer and remove the Cone to
empty. Once empty, replace the Cone and continue juicing.
CLEANING THE MODEL 5000
Rinse all removable parts under hot water.
To Next Page
Loading...
Need help?
General
