Omega CN16Pt - 4. Reference Section: Initialization Mode (INIt); 4.1 Input Configuration (INIt > INPt); 4.1.1 Thermocouple Input Type (INIt > INPt > t.C.)

PLATINUM
TM
Series User’s Guide
22
Reference Section: Initialization Mode (INIt)
Level
2
Level
3
Level
4
Notes
VALy
Displays the lowest input reading since the VALy was last cleared
PEAk
Displays the highest input reading since the PEAk was last cleared
Stby
Standby Mode, outputs, and Alarm conditions disabled, displays Stby
4. Reference Section: Initialization Mode (INIt)
Use Initialization Mode to set the following parameters and perform the following functions:
4.1 Input Configuration (INIt > INPt) ................................................................................................. 22
4.2 Display Reading Formats (INIt > RdG) ......................................................................................... 25
4.3 Excitation Voltage (INIt > ECtN) .................................................................................................. 27
4.4 Communication (INIt > CoMM) ................................................................................................... 28
4.5 Safety Features (INIt > SFty) ........................................................................................................ 31
4.6 Manual Temperature Calibration (INIt > t.CAL) .......................................................................... 32
4.7 Save Current Configuration for All Parameters to a File (INIt > SAVE) ....................................... 33
4.8 Load a Configuration for All Parameters from a File (INIt > LoAd) ............................................. 34
4.9 Display Firmware Revision Number (INIt > VER.N) ..................................................................... 34
4.10 Update Firmware Revision (INIt > VER.U) ................................................................................... 34
4.11 Reset to Factory Default Parameters (INIt > F.dFt) ..................................................................... 34
4.12 Password-Protect Initialization Mode Access (INIt > I.Pwd) ....................................................... 34
4.13 Password-Protect Programming Mode Access (INIt > P.Pwd) .................................................... 34
4.1 Input Configuration (INIt > INPt)
Select the Input parameter (INPt) to configure the input.
Navigate to the correct setting. Settings include the following:
• t.C. – Thermocouple Temperature Sensor (entry point)
• Rtd – Resistance Temperature Detector (RTD)
• tHRM – Thermistor Temperature Sensor
• PRoC – Process Voltage or Current Input
Select the indicated setting.
4.1.1 Thermocouple Input Type (INIt > INPt > t.C.)
Select Thermocouple (t.C.) as the input type (factory default). Then specify a specific type of
thermocouple or the last selected type will be used.
Omega Engineering | www.omega.com