Omega CN16Pt - 4.2.5 Normal Color (INIt > RdG > NCLR); 4.2.6 Brightness (INIt > RdG > bRGt); 4.3 Excitation Voltage (INIt > ECtN)

PLATINUM
TM
Series User’s Guide
27
Reference Section: Initialization Mode (INIt)
Navigate to the desired setting. Settings include the following:
• ALM.1 – The configuration defined by PRoG > ALM.1 determines the state of the
annunciator. The annunciator turns on when the Alarm condition exists (factory
default for ANN.1).
• ALM.2 – The configuration defined by PRoG > ALM.2 determines the state of the
annunciator (factory default for ANN.2).
• oUt# – “oUt#” is replaced by a list of the names of all outputs that are not analog
outputs. For example, the output choices dtR.1 and dC.1 are listed for a “145”
configuration, and ANG.1 is not listed.
Select the indicated option.
4.2.5 Normal Color (INIt > RdG > NCLR)
Select the Normal Color (NCLR) parameter. This controls the default display color, which can
then be overridden by Alarms.
Navigate to the desired setting. Settings include the following:
• GRN – Green (factory default)
• REd – Red
• AMbR – Amber
Select the indicated option.
4.2.6 Brightness (INIt > RdG > bRGt)
Select the Brightness (bRGt) parameter.
Navigate to the desired setting. Settings include the following:
• HIGH – High display brightness (factory default)
• MEd – Medium display brightness
• Low – Low display brightness
Select the indicated option.
4.3 Excitation Voltage (INIt > ECtN)
Select the Excitation Voltage (ECtN) parameter.
Navigate to the correct setting. Settings include the following:
• 5 V – 5 Volt excitation voltage (factory default)
• 10 V – 10 Volt excitation voltage
• 12 V – 12 Volt excitation voltage
• 24 V – 24 Volt excitation voltage
• 0 V – Excitation turned off
Select the indicated option.
Omega Engineering | www.omega.com