Omega CN16Pt - 5. Reference Section: Programming Mode (PROG); 5.1 Setpoint 1 Configuration (PRoG > SP1); 5.2 Setpoint 2 Configuration (PRoG > SP2)

PLATINUM
TM
Series User’s Guide
35
Reference Section: Programming Mode (PRoG)
Navigate to the desired setting. Settings include the following:
• No – Do not require a password for PRoG Mode (factory default)
• yES – Require a password for PRoG Mode; users will be prompted for this password
when selecting PRoG
Select the indicated setting.
If yES, set the numeric password from the range 0000–9999.
Confirm the password.
5. Reference Section: Programming Mode (PRoG)
Use Programming Mode to set the following parameters and perform the following functions:
5.1 Setpoint 1 Configuration (PRoG > SP1) ....................................................................................... 35
5.2 Setpoint 2 Configuration (PRoG > SP2) ....................................................................................... 35
5.3 Alarm Mode Configuration (PRoG > ALM.1, ALM.2)................................................................... 36
5.4 Output Channel 1–4 Configuration (PRoG > oUt.1–oUt.4) ......................................................... 40
5.5 PID Configuration (PRoG > PId) ................................................................................................... 43
5.6 Remote Setpoint Configuration (PRoG > RM.SP) ........................................................................ 46
5.7 Multi-Ramp/Soak Mode Parameters (PRoG > M.RMP) .............................................................. 48
5.1 Setpoint 1 Configuration (PRoG > SP1)
Select the Setpoint 1 (SP1) parameter.
Set the process goal value for PId or oN.oF control.
Confirm the value.
5.2 Setpoint 2 Configuration (PRoG > SP2)
Select the Setpoint 2 (SP2) parameter. SP2 is used with Alarm functions and with on/off
control when setting up for Heat/Cool Control Mode.
Navigate to the desired setting. Settings include the following:
• ASbo – The value for SP2 is specified in Absolute Mode (factory default)
• dEVI – The value specified for SP2 indicates an offset (positive or negative) from
SP1; this allows SP2 to track any changes to SP1 automatically
Select the indicated setting.
Set the correct value.
Confirm the value.
Omega Engineering | www.omega.com