PLATINUM
TM
Series User’s Guide
4.3 Excitation Voltage (INIt > ECtN) .................................................................................................. 27
4.4 Communication (INIt > CoMM) ................................................................................................... 28
4.4.1 Protocol (INIt > CoMM > USb, EtHN, SER > PRot) ............................................................... 28
4.4.2 Address (INIt > CoMM > USb, EtHN, SER > AddR) ............................................................... 29
4.4.3 Serial Communications Parameters (INIt > CoMM > SER >C.PAR) ..................................... 29
4.5 Safety Features (INIt > SFty) ........................................................................................................ 31
4.5.1 Power On Confirmation (INIt > SFty > PwoN) ..................................................................... 31
4.5.2 Operating Mode Confirmation (INIt > SFty > oPER) ............................................................ 31
4.5.3 Setpoint Limits (INIt > SFty > SP.LM) ................................................................................... 31
4.5.4 Loop Break Timeout (INIt > SFty > LPbk) ............................................................................. 32
4.5.5 Open Circuit (INIt > SFty > o.CRk)........................................................................................ 32
4.6 Manual Temperature Calibration (INIt > t.CAL) .......................................................................... 32
4.6.1 No Manual Temperature Calibration Adjustment (INIt > t.CAL > NoNE)............................ 33
4.6.2 Manual Temperature Calibration Offset Adjustment (INIt > t.CAL > 1.PNt) ...................... 33
4.6.3 Manual Temperature Calibration Offset and Slope Adjustment (INIt > t.CAL > 2.PNt) ...... 33
4.6.4 Temperature Ice Point Calibration (INIt > t.CAL > ICE.P) .................................................... 33
4.7 Save Current Configuration for All Parameters to a File (INIt > SAVE) ....................................... 33
4.8 Load a Configuration for All Parameters from a File (INIt > LoAd) ............................................. 34
4.9 Display Firmware Revision Number (INIt > VER.N) ..................................................................... 34
4.10 Update Firmware Revision (INIt > VER.U) ................................................................................... 34
4.11 Reset to Factory Default Parameters (INIt > F.dFt) ..................................................................... 34
4.12 Password-Protect Initialization Mode Access (INIt > I.Pwd) ....................................................... 34
4.13 Password-Protect Programming Mode Access (INIt > P.Pwd) .................................................... 34
5. Reference Section: Programming Mode (PRoG) ................................................................................ 35
5.1 Setpoint 1 Configuration (PRoG > SP1) ....................................................................................... 35
5.2 Setpoint 2 Configuration (PRoG > SP2) ....................................................................................... 35
5.3 Alarm Mode Configuration (PRoG > ALM.1, ALM.2)................................................................... 36
5.3.1 Alarm Type (PRoG > ALM.1, ALM.2 > tyPE)......................................................................... 36
5.3.2 Absolute or Deviation Alarm (PRoG > ALM.1, ALM.2 > tyPE > Ab.dV) ................................ 37
5.3.3 Alarm High Reference (PRoG > ALM.1, ALM.2 > tyPE > ALR.H) .......................................... 37
5.3.4 Alarm Low Reference (PRoG > ALM.1, ALM.2 > tyPE > ALR.L) ............................................ 37
5.3.5 Alarm Color (PRoG > ALM.1, ALM.2 > A.CLR) ...................................................................... 38
Omega Engineering | www.omega.com
To Next Page
Loading...
