Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the us er instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warnin g light in the control pa nel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap and press the Start/reset butto n. The machine will start working
after about 10 seconds.
Running the dishw asher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unload ing the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Press the Programme butto n until the selected programme lights up.
( See the section entitled Operationg instruction )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he door car efull y.
Hot steam may escape
when thedoor isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwa sher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the appliance, Open the door.
1.Open the doo r a little to sto p the dishwasher.
2.After the spray arms stop working, you can open the d oor completely.
3.Add the forgotten dishes.
4.Close the door and press the star t button, the dishwasher will start ru nning
again after 10 seco nds.
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the deterg ent
m ay have already been released and the water a lready drained. If this is the case, the de tergent
dispenser must be refilled.
2. Press programme button for more than 3 seconds to cancel the running programme.
3. Select a new programme.
To Next Page
Loading...
