25
HOW TO DISASSEMBLE AND CLEAN
After the product stops operating completely, pull
the power cord plug with dry hands. Even after the
product is stopped, the motor will slowly come to a
stop so wait about 3 seconds before detaching the
chamber set.
1 Detach the chamber set from the product body.
Turn the hopper to open it and then sequentially
pull each of the parts to disassemble them.
2 Wash the parts with a cleaning brush under
running water.
3 Open the discharge cover and juice cap to
clean the chamber.
4 Wipe the product body with a damp towel or soft
cloth.
5 Detach and wash silicone packings after use.
- Residue may still be stuck. (hopper packing, juice
cap packing, extraction packing, seal packing,
chamber packing).
6 You can sterilize the parts by soaking them in
warm water diluted with baking soda, citric acid or
vinegar.
Failure to clean the product immediately after use
may cause its stainless steel parts and other parts
to corrode or become discolored due to salt and
pulp from the ingredients. Also, contaminants
may be dried up and stuck inside, which makes it
difcult to disassemble and clean them and may
also cause performance impairment. Be sure to
clean and airdry it completely immediately after
use and store it in a clean place. For long-term
storage, use a cleaning brush to wash it. Do not
clean with boiling or high temperature water or use
a cleansing sponge, steel sponge, abrasives and
other sharp cleaning tools. Do not place parts in
dishwasher.
To Next Page
Loading...
Need help?
General
