Set up relative value: When setting up relative value the third display will show 0 at beginning of set up. Press
, , , , keys to select value
and highlight , then use
then press .
Set up range is limited to the highest
and lowest temperature range that each
thermocouple can be measured. Adjust
to the set up value that you want then
press key to finish set up.
Can set up the range in every type
thermocouple:
K-TYPE：
：：
： -200°C to 1372°C
(-328°F to 2501°F)
(-346°F to 2192°F)
J-TYPE：
：：
： -210°C to 1200°C
(-418°F to 752°F)
-250°C to 400°C
(-346°F to 1832°F)
-210°C to 1000°C
(-238°F to 2372°F)
-150°C to 1300°C
(-32°F to 3212°F)
0°C to 1767°C
T-TYPE：
E-TYPE：
：：
：
R- S-TYPE
：
N-TYPE：
＞
Press to move right one-figure that adjusted. ＞Press to move left one-figure that adjusted when in
Press key then press key, third display shows CLEA to clear set relative
value, press key again to finish clearing.
Rel value set mode.
Set up compensation value of cold junction of 0°C of thermocouple: Use and main display (T1 or T2)
thermocouple of the same type, from main
display (T1 or T2) inputs 0°C (32°F) temperature
value, adjust third display shows the co
ld junction
compensating value, enable main display shows
0°C (32°F). Press key again to finish setting up.
third display shows the cold junction
compensating value and the adjusting range is
about 0°C~50°C (32°F~122°F), will show Err and
unable to continue adjusting when exceeding the
range, need to press key to give up leaving.
The set up cold junction compensating value need
to use Reset add key to clear the set up value.
＞
Press to move right one-figure that adjusted.
＞Press to move left one-figure that adjusted.
＞
Press to add one-figure upward that adjusted.
＞Press to minus one-figure downward that
adjusted.
Note: Operation of Reset, please consult Reset function explanation.
MAX
MIN
C
F
or
or
or
SET
SET
SET
SET
C
F
SET
SET
SET
C
F
MAX
MI N
T
MAX
MIN
C
F
SET
SET
SET
SET
ET
C
F
C
F
MAX
MI N
11
To Next Page
Loading...
