Omega MICROMEGA CN77000 series - Page 67

O PERATION : C ONFIGURATION M ODE
part
3
Ramp & Soak cont.
Display Action Response
RAMP VALUE SUBMENU:
Press ENTER 9) Display flashes 1st digit of previous
"
raMp
" value.
Press MAX & MIN 10) Press MAX and MIN buttons to enter a new
"
raMp
" value.
Press ENTER 11) Display flashes
"
strd
" message and advances to "Soak Value" submenu.
SOAK VALUE SUBMENU:
Press ENTER 9) Display flashes 1st digit of previous "Soak" value.
Press MAX & MIN 10) Press MAX and MIN buttons to enter a new "Soak" value.
Press ENTER 11) Display flashes
"
strd
" message and advances to the "Analog Output".
The Ramp & Soak time is 00:00 to 99:59 i.e. HH.MM.(from zero to 99 hours and 59 minutes)
During Ramp & Soak do not perform any operations or settings before first pressing MENU and MIN buttons or
using software disable Ramp. Any alarms or other output are disabled during this time.
SoAc
05.67
RAMp
05.67
Note
☞
59