Adding one Chart to Group 1
4. Change the number of charts per group if desired.
5. Change the group name if desired.
6. Click on a group to see the chart(s) assigned to the group. In the above example there is one group
with one chart.
7. Click on a chart to assign channels to the chart. A screen similar to the following will appear.
Assigning Channels to Group 1, Chart 1
8. Choose channels for the selected chart. You can select up to 4 overlapping channels per chart. Add or
delete channels as follows:
• Highlight an available channel using the cursor and left-hand mouse button; then click
the Add button. Repeat for each channel to be added.
• Double-click on a channel in the available channels list to add the channel to the display.
• Double-click on a channel in the selected channels list to remove the channel from the
display.
• Hold down the keyboard’s Shift Key and use the left-hand mouse button to select a block
of consecutive available channels (up to 4); then click the Add button. Example:
PD1_A03, PD1_A04, PD1_A05, PD1_A06.
• Hold down the keyboard’s Ctrl button and use the left-hand mouse button to select up to
4 available channels (these can be non-consecutive); then click the Add button.
Example: PD1_A01, PD1_A03, PD1_A05, PD1_A07.
Note: You can also remove channels in a similar manner by highlighting a channel(s) in the Selected
Channels box, and then clicking on the Remove button.
Personal Daq User’s Manual 989394 Personal DaqView 4-35
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...