What to do if my Omnik New Energy Co., Ltd. Inverter shows Utility Loss?
If your Omnik New Energy Co., Ltd. Inverter displays a Utility Loss error, it means the grid is not connected. Check the grid connection cables and ensure the grid is working. If the grid is functional and the issue persists, the inverter's fuse may be open, requiring professional service.
What to do if my Omnik New Energy Co., Ltd. Inverter is Over Temperature?
If your Omnik New Energy Co., Ltd. Inverter is showing an over-temperature warning, it means that the internal temperature is higher than the specified normal value. Try to reduce the ambient temperature around the inverter or move it to a cooler environment.
What to do if my Omnik New Energy Co., Ltd. Inverter shows Grid Fault Fac Failure?
If your Omnik New Energy Co., Ltd. Inverter displays a Grid Fault Fac Failure message, wait a moment to see if the grid returns to normal, allowing the PV-Inverter to restart automatically. Also, verify that the grid voltage and frequency meet the required specifications.
What to do if my Omnik New Energy Co., Ltd. Inverter displays PV Over Voltage?
If your Omnik New Energy Co., Ltd. Inverter shows a PV Over Voltage error, check the open PV voltage to ensure it is not greater than or too close to 1000VDC (specifically for Omniksol-13k-TL, Omniksol-17k-TL, or Omniksol-20k-TL models). If the PV voltage is less than 1000VDC and the problem persists, contact local service.
What to do if my Omnik New Energy Co., Ltd. Inverter shows Ground I Fault?
If your Omnik New Energy Co., Ltd. Inverter displays a Ground I Fault, it means the ground current is too high. Cut off the AC side connection, unplug the inputs from the PV generator, and check the peripheral AC system. After clearing the cause, re-plug the PV panel and AC connection, then check the PV-Inverter status.
How to fix Isolation Fault on Omnik New Energy Co., Ltd. Inverter?
To address an Isolation Fault on your Omnik New Energy Co., Ltd. Inverter: * Check the impedance between PV (+) & PV (-) and the inverter is earthed, ensuring it is greater than 2.4MΩ. * Check whether the AC-side has contacts with earth.
What to do if my Omnik New Energy Co., Ltd. Inverter displays a Consistent Fault error?
If your Omnik New Energy Co., Ltd. Inverter shows a Consistent Fault error (Fac differs for M-S, Vac differs for M-S, Ground I differs for M-S, DC inj. differs for M-S), disconnect PV (+) or PV (-) from the input and restart the inverter.
What to do if my Omnik New Energy Co., Ltd. Inverter shows AC Relay Check Fail?
If your Omnik New Energy Co., Ltd. Inverter displays 'AC Relay Check Fail': 1. Disconnect ALL PV (+) or PV (-). 2. Wait a few seconds. 3. After the LCD switches off, reconnect and check again. 4. If the problems remain please call local service.
General| Model | Omniksol-13k-TL |
|---|---|
| Rated Power | 13000W |
| Max. DC Voltage | 1000V |
| Maximum DC Input Voltage | 1000V |
| Number of MPPTs | 2 |
| Rated AC Power | 13000W |
| THDI | <3% |
| Protection Class | IP65 |
| AC Grid Frequency | 50 Hz / 60 Hz |
| DC Switch | Yes |
| Operating Temperature Range | -25°C to 60°C |
| Communication | WiFi / Ethernet |
| Inputs per MPPT | 2 |
To Next Page