3-51
D Setting Parameters
Once the parameters have been displayed using the individual operations, perform the following opera-
tions to set the parameter data.
• Use the Up and Down Keys to increase or decrease the numeric value of the digit that is flashing.
• Press the Forward Key to shift to the next digit to the left. If the Forward Key is pressed while the left-
most digit is flashing, the rightmost digit will start flashing.
• If a parameter has two items to be set (e.g., advance angle compensation value 1), the data will be
displayed in the SPEED/ON and POSITION/OFF displays.
• As the final step, press the Set Key to confirm the settings. When the Set Key is pressed, the data will
remain lit for approximately one second and then one of the digits will start flashing again.
Operation Chapter 3
To Next Page
Loading...
