3-73
Setting/Releasing Cam Protect Procedure 2 (Setting/Releasing Cam Protect within a Set Bank)
w Setting/Releasing Cam Protect by Bank
Cam protect (bank number 1, cam number 1)Cam protect (bank number 1)
Set
Release
For 3F88L-162 (32-point model)
Cam Positioners
”C” flashes twice
Bank number selection enabled
(Bank/Function display flashing)
”C” flashes twice
Cam protect settings possible
(present setting status displayed)
Confirm settings
Confirm settings
S While the bank and cam numbers are displayed (cam protect settings enabled), press the ON/
OFF Switching Key while pressing the Up Key to set cam protect for all cams within that bank num-
ber.
S While the bank and cam numbers are displayed (cam protect settings enabled), press the ON/
OFF Switching Key while pressing the Down Key to release cam protect for all cams within that
bank number.
S Once cam protect has been set or released, press the Set Key to confirm the cam protect settings.
“C” will flash twice on the display. (Perform this operation for each bank. The setting will be can-
celed if the Set Key is not pressed before moving to another bank.)
S Once the settings have been completed, press the Clear Key to return to bank selection enabled
status (Bank/Function display flashing).
S To set or release cam protect for another bank number (the above operation), use the Up and
Down Keys when in bank selection enabled status (Bank/Function display flashing) to select the
new bank number, and repeat the above operation.
S Press the Bank/Function Key when in bank selection enabled status (Bank/Function display flash-
ing) to return to function number setting status (”C” displayed in the Bank/Function display).
Operation Chapter 3
To Next Page
Loading...
