Function level 2
3-83
• Press the Set Key. The data will remain lit for approximately one second, the settings will be confirmed,
and then the data will resume flashing again.
• If the data is inappropriate and the Set Key is pressed, all displays will flash twice and then return to the
settings before the data was edited. Re-input the correct data.
3-6-12 Teaching
H Function
• The teaching function is used to input data from the Resolver as ON/OFF angle settings while the ma-
chinery is being manually operated.
• The only editing of cam programs allowed while using this function is the registration or deletion of
ON/OFF angle data.
Note 1. If the teaching function is used on cam numbers for which a cam program has already been
input, steps will be added to that cam program.
Note 2. The ON or OFF angles for cam programs that have been already input cannot be changed
separately.
Note 3. The teaching function cannot be used if the Resolver speed is 4 r/min or greater.
H Related Parameter (SET Mode)
D Teaching
Function
No.
d (d)
Parameter
No.
--- Setting range ---
• Use this parameter to create cam programs.
Operation Chapter 3
To Next Page
Loading...
