3-25
Once a program has been checked for one cam number, change the cam number (using the Cam/Pa-
rameter Key) and check another cam program in the same way. If multiple bank numbers are used,
change the bank number (using the Bank/Function Key) and check another program in the same way.
D Cam Program Deletion (PRGM Mode)
There four methods to delete cam programs. Each of these methods will be explained in this section.
• ON/OFF angle data deleted by steps.
• ON/OFF angle data deleted by cam numbers.
• ON/OFF angle data deleted by bank numbers.
• All cam programs deleted at once.
Deleting by Step (PRGM Mode)
Operation Explanation
1 Set the mode selection switch to PRGM mode.
2
BANK/
FUN
Press the Bank/Function Key and set the bank number that contains
the step to be deleted.
3
CAM/
PRMTR
Press the Cam/Parameter Key and set the cam number that contains
the step to be deleted.
4
SET
Press the Set Key to display the step to be deleted.
5
CLR
Press the Clear Key once. (The ON angle and OFF angle displays will
start flashing.)
6
SET
Press the Set Key to delete the step.
Deleting by Cam Number (PRGM Mode)
Operation Explanation
1 Set the mode selection switch to PRGM mode.
2
BANK/
FUN
Press the Bank/Function Key and set the bank number that contains
the cam number to be deleted.
3
CAM/
PRMTR
Press the Cam/Parameter Key and set the cam number that is to be
deleted.
4
CLR CLR
Press the Clear Key twice. (The cam number display will start flashing.)
5
SET
Press the Set Key to delete the cam number.
Operation Chapter 3
To Next Page
Loading...
