3-26
Deleting by Bank Number (PRGM Mode)
Operation Explanation
1 Set the mode selection switch to PRGM mode.
2
BANK/
FUN
Press the Bank/Function Key and set the bank number that is to be
deleted.
3
CLR CLR CLR
Press the Clear Key three times. (The bank number display will start
flashing.)
4
SET
Press the Set Key to delete the bank number.
Deleting All Cam Programs (PRGM Mode)
Operation Explanation
1 Set the mode selection switch to PRGM mode.
2 Press the P⋅CLR switch to clear all cam programs in the Cam
Positioner.
Note The P⋅CLR switch will be ignored by the system, even in PRGM mode, if the trial operation function is
being used. Trial operation cannot be performed in function level 1.
D Checking Number of Programs (SET Mode)
Check the number of cam program steps that have been created.
Operation Explanation
1 Set the mode selection switch to SET mode.
2
BANK/
FUN
Press the Bank/Function Key and set the bank number that contains
the cam number to be checked.
3
CAM/
PRMTR
Press the Cam/Parameter Key and set the cam number to be checked.
4 The number of steps for that cam program will appear in the
SPEED/ON display.
Once the number of steps for one cam number have been checked, change the cam number (using
Cam/Parameter Key) and check another cam number in the same way.
If multiple bank numbers are used, change the bank number (using the Bank/Function Key) and check
another bank number in the same way.
Operation Chapter 3
To Next Page
Loading...
