Omron 3G3MV-PDRT2 - Page 196

Chapter 7
7-46
Configurator Settings
Note When the 3G3MV is used, all parameters can be set from the Configurator.
● 3G3RV/3G3PV
Parameter Groups
Parameters that Cannot be Set on the Inverter Parameters Tab Page
(Use the Individual Parameters Tab Page)
n176 01 B0 Parameter copy and verify function selection (read only)
n177 01 B1
n178 01 B2 Fault log
Parameter group Details
All Parameters A: Initialize Mode Parameters A: Environment settings
B: Application Parameters B: Application
C: Tuning Parameters C: Tuning
D: Reference Parameters D: Reference
E: Motor Constant Parameters E: Motor constant
F: Option Parameters F: Option
H: Terminal Function Parameters H: Terminal function setting
L: Protection Function Parameters L: Protection function
N: Special Adjustments N: Special adjustments
O: Digital Operator Parameters O: Operator
Enter Code Enter code
Monitor Speed reference, speed monitor, current moni-
tor, output voltage
Parameter
No.
Class 64 Details
Instance Attribute
A1-00 01 00 Language selection for Digital Operator display
A1-01 01 01 Parameter access level
A1-040104Password
A1-05 01 05 Password setting
b4-01 01 A3 Timer function ON-delay time
b4-02 01 A4 Timer function OFF-delay time
C6-03 02 25 Carrier frequency upper limit
C6-04 02 26 Carrier frequency lower limit
C6-05 02 27 Carrier frequency proportional gain
E3 03 19 to 20 Motor 2 V/f pattern
E4 03 21 to 27 Motor 2 set values
H4-02 04 1E Multi-function analog output 1 (terminal FM) output gain
H4-03 04 1F Multi-function analog output 1 (terminal FM) bias
H4-05 04 21 Multi-function analog output 2 (terminal AM) output gain
H4-06 04 22 Multi-function analog output 2 (terminal AM) bias
Parameter
No.
Class 64 Details
Instance Attribute