Chapter 1
1-10
Functions and System Configuration
The 3G3MV-PDRT2 is equipped with a connector for DeviceNet connection rather than a terminal
block. The dimension of the connector that extends below the case must be added.
■ Inverter Software Versions
Supported software versions are listed in the following table.
Model Software version Release date Description
3G3MV Series,
3.7 kW and less
VSP010027 (S0027)
and higher
June 2003 Supports all functions.
Current trace function and warning torque
detection function use increments of 0.01 A.
VSP010026 (S0026) June 2002 Supports all functions.
Current trace function and warning torque
detection function are use increments of
0.1 A for detection and display.
VSP010025 (S0025) June 2001
VSP010024 (S0024) September 2000
3G3MV Series,
5.5 kW and more
VSP010105 (S0105) September 2002 Supports all functions.
Current trace function and warning torque
detection function are use increments of
0.1 A for detection and display.
VSP010104 (S0104) May 2001
3G3RV Series VSF105081 (S5081)
and higher
November 2001 Supports all functions.
Current trace function and warning torque
detection function are use increments of
0.1 A for detection and display.
3G3PV Series VSE102014 (S2014) July 2002 Supports all functions.
Current trace function and warning torque
detection function are use increments of
0.1 A for detection and display.
VSE102013 (S2013) March 2001
3G3FV Series VSG101114 (S1114) September 2002 It is not possible to force-switch the com-
mand right from the network. Specifically,
even if netref and netctrl (see Chapter 5
Remote I/O Functions) are turned ON, the
command right will not be switched to the
network. Use parameters b1-02 and b1-01
to set the command right.
There are no restrictions to other functions.
VSG101113 (S1113) September 2000
VSG101043 (S1043) September 1998
To Next Page
Loading...
