Omron 3G3MV-PDRT2 - Setting the Node Address from the Configurator

Chapter 3
3-5
Setup and Wiring
■ Setting the Node Address from the Configurator
1.Double-click the icon of the corresponding Slave (Inverter) in the Network Configuration Window,
or click the right mouse button over the icon and select Change Node Address.
2. A Node Address Setting Window will be displayed. Input the desired node address.
3.Click the OK Button.
Note Any node address between 0 and 63 can be set as long is it is not duplicated in another Master
or Slave in the network. If the node address is duplicated in another node in the network, an
error will occur and the Slave will not be able to participate in network communications.