Omron CM2 - Positioning the Arm Correctly; Hints for Measurement; Maintenance Guidelines

EN
3
2. Position the arm correctly.
1) The air tube should run down the inside of your
IRUHDUPDQGEHLQOLQHZLWK\RXUPLGGOH¿QJHU
2) 7KHERWWRPRIWKHFXႇVKRXOGEHDSSUR[LPDWHO\
to 2 cm above your elbow.
3) $SSO\WKHFXႇWR\RXUXSSHUDUPVRWKDWWKH
marker (arrow under tube) is centered on the
middle of your inner arm and points down the
inside of the arm.
7DNLQJPHDVXUHPHQWVRQWKHULJKWDUP
$SSO\WKHFXႇVRWKDWWKHDLUWXEHLVDWWKHVLGHRI
your elbow.
 %HFDUHIXOQRWWRUHVW\RXUDUPRQWKHDLUWXEHRU
RWKHUZLVHUHVWULFWWKHÀRZRIDLUWRWKHFXႇ
 7KHFXႇVKRXOGEHWRFPDERYHWKHHOERZ
3.:KHQWKHFXႇLVSRVLWLRQHGFRUUHFWO\FORVHWKH
fabric fastener FIRMLY.
• 'RQRWSODFHWKHFXႇRYHUWKLFNFORWKHVDQGGRQRW
roll up your sleeve if it is too tight.
• $OLJQWKHFXႇZLWKWKHKHLJKWRI\RXUKHDUWEUHDVW
height). If necessary use a pillow or cushion.
• Use a soft and dry cloth, or a soft and moistened
FORWKDQGQHXWUDOVRDSWRFOHDQRQWKHDUPFXႇ
• Do not use petrol, thinners of similar solvents to
FOHDQWKHDUPFXႇ
• 'RQRWVWRUHWKHDUPFXႇWRH[WUHPHWHPSHUDWXUHV
humidity, direct sunlight, dust or corrosive vapours.
• 'RQRWEHQGRUFUHDVHWKHDLUWXEHH[FHVVLYHO\
2.
1 – 2 cm
Hints
Maintenance
Please report to the manufacturer and the competent authority of the Member State in which
you are established about any serious incident that has occurred in relation to this device.