Omron CQM1H series - Mounting and Dismounting the Sensor Module

140
Mutual Interference When installing two or more sensors face to face or side by side, ensure that the
minimum distances given in the following table are maintained. Sensors can be
mounted together in parallel, however, if their cable length switches are set to
different values.
A
B
Model
Distance (mm)
A B
E2C-CR5B 20 15
E2C-CR8j
20 15
E2C-X1A 20 15
E2C-C1A 20 15
E2C-X1R5A 20 15
3-2 Mounting and Dismounting the Sensor Module
Mounting
Mount the E3C-MA11 securely to the Sensor Unit so that the fiber sensor con-
nector side is on the left and the indicator side is on the right.
Dismounting A pulling tool is provided with the Sensor Unit. To dismount the E3C-MA11 from
the Sensor Unit, hook the pulling tool onto the square hole on the right side of the
E3C-MA11 and pull out the E3C-MA11 carefully.
Pulling tool
Note Be sure to turn off the CQM1-SEN001 before mounting or dismounting sensor
modules.
Mounting and Dismounting the Sensor Module
Section 3-2