241
5. The set points and input shift values will change as follows if the input type is
changed:
• The set points will be clamped at the upper or lower limit if the setting range
is exceeded.
• The decimal points will be adjusted if the range is changed to another
range with a different number of decimal places.
Example: If pin 1 on SW2 is turned ON, the K thermocouple range will be
changed from –200 to 1,300 °C to 0.0 to 500.0 °C. If a set point was pre-
viously 200 °C, it will be changed to 20.0 °C.
Nomenclature
Section 2-3
To Next Page
Loading...
