FH-VPX-FZ
l
Connection Structure (FH-VPX-FZ)
PLC, terminal blocks or
other products
FZ-VP / FZ-VPX
CN3
CN1
CN2
FH-VPX-FZ
Power supply used
in the FH controller:
Power supply S8VS
series (24 VDC)
Parallel connector
(CN1/CN2)
FH controller
Connecting the FZ-VP and the FH-VPX-
* After the connection, lock it securely.
Connector No. Connection destination Note
CN1 Connect to the parallel port CN1 on the Sensor Con-
troller
.
Even if you connect the CN1 and
CN2 reversely by mistake, it does
not work but will not be damaged.
CN2 Connect to the parallel port CN2 on the Sensor Con-
troller
.
CN3
Connect to the parallel I/O cable, FZ-VP£
-
l
Cable (FH-VPX-FZ)
CN3
CN1
CN2
8
34
40
500
(35)
(20)
7
(Unit: mm)
47.8
6 I/O Interface
6-20
FH Series Vision System Hardware Setup Manual (Z366-E1)
To Next Page
Loading...
