Clearing the Settings
Partial clearing
Clearing all the settings in an entire circuit
Programming for 4-circuit models
The following shows how to program (select the output circuit
number) for 4-circuit models.
About Yearly Programs
Yearly programs in addition to ordinary weekly programs can be set
for 2- and 4-circuit yearly models.
Note: 1. This example combines the following programs.
For details on yearly programming, refer to page 19.
Weekly program
Friday, Saturday, and Sunday: 9:00 (ON time),
18:00 (OFF time)
Yearly program
March 25: 18:00 (ON time), 22:15 (OFF time)
2. For details on automatically switching the weekly program
depending on the season, refer to page 24.
To set multiple-day operation for a yearly program, two yearly
programs must to be set as shown in the following example.
Note: Do not enter a weekly program.
Weekly, 2 Circuits Yearly, 2 Circuits Yearly, 4 Circuits
1. Set the Mode Switch to P1 or P2 and
select the setting to be cleared.
Shaded portion indicates
blinking of the indicator.
2. Press briefly.
3. Press to clear the setting. *
1. Set the Mode Switch to the position
for the circuit whose settings are to
be cleared.
Shaded portion indicates
blinking of the indicator.
2. Press and hold for 3 s or
more.
3. Press to clear all the settings of the circuit. *
* The clearing operation can be cancelled by pressing
while clr is displayed.
Yearly, 4 Circuits
1. Set the Mode Switch to PRGM.
(The Time Switch enters program
setting mode.)
Shaded portion indicates
blinking of the indicator.
2. Select an output circuit with
. Pressing the key
changes the set circuit number
displayed in the lower right corner of
the LCD.
The rest of the procedure is the same
as for 2-circuit models.
Note: The circuit number cannot be changed during the course of
setting.