22
8.General Preparation
8.4. Setting the Blood Pressure/AI Measurement Method and Registering
ID Information
1. Setting the Blood Pressure/AI Measurement Methods
There are three methods for blood pressure measurement: Single, Average - 2 times, and
Average - 3 times.
The default setting is [SINGLE].
To change this setting, follow the instructions in Section 18.3.
When measuring AI, the duration can be set to any of the following: 15 seconds, 30
seconds, 1 minute, or 3 minutes.
The measurement time set here is the duration of the pulse wave sampling. The total time
required for measurement is slightly longer.
The default setting is [30] seconds.
To change this setting, follow the instructions in Section 18.3.
2. Registering the patient’s ID
Register the patient’s ID before beginning measurement to continuously track trends/
transitions in the measurement results.
Follow the procedure outlined in Section 17.1. to register the ID information.
To Next Page
Loading...
